Upgrade your front loader with these high - quality carbon motor brushes. Designed to fit AEG, Hoover, Whirlpool, Electrolux, Zanussi models with a Sole motor. Part number is HV12102. Similar to BT - 419, UN12102, and BT421, but with carbons facing the opposite way. They're equivalent to various Hoover Candy and Whirlpool part numbers. These carbon brushes can replace many European front loader motor brushes on machines from well - known brands like AEG, Baumatic, Belling, Hoover Candy, Whirlpool, Maytag, Electrolux, and Zanussi. The carbon dimensions are 38mm long, 4.8mm thick, and 12.5mm wide. The mounting holes are 24mm apart, and the locating spikes are 18.5mm apart. The mounting holes are 19mm from the front end of the brushholder, and the front locating spike is 9mm from the front. The brushholder has PA - GF on the bottom, and the carbon brush has 055 Y1302 printed on the side. It features 4.8mm spade terminals protruding to the side and suits models with a reverse - type Sole motor. With over 25 years of experience supplying appliance parts to both trade and retail, you can buy with confidence.
Using these carbon motor brushes is straightforward. First, make sure your front loader is unplugged to avoid any electrical hazards. Then, locate the old motor brushes in your machine and carefully remove them. Place the new carbon motor brushes in the same position, ensuring that the mounting holes and locating spikes align correctly. Once installed, plug your front loader back in and test it. When it comes to maintenance, check the brushes regularly for wear and tear. If you notice excessive wear, it's time to replace them. Also, keep the brush area clean to ensure optimal performance. And remember, these brushes are designed specifically for models with a reverse - type Sole motor, so make sure your machine is compatible before installation.
