Discover our top - notch Creda and Delco Carbon Motor Brushes (Pr). These brushes are identified by Qualtex Part No. CAR01 and Morganite Part No. DA1(SD3). They are a perfect fit for Creda and Delco washing machine spin motors DA1 / SD3. Additionally, they might also work well with some Kenwood Chef food processors, blenders, and food mixers, like models A701 and A707. The brush dimensions are 5.5mm X 4.0mm X 18.0mm long, and they come with springs. The round contact diameter is 7mm. With over 25 years of experience supplying appliance parts to both trade and retail, you can buy with full confidence.
Using these carbon motor brushes is quite simple. First, make sure your appliance is turned off and unplugged for safety. Then, locate the old brushes in your washing machine spin motor or Kenwood Chef appliance. Remove the old ones carefully and replace them with these new brushes. Just match the dimensions and make sure the springs are properly in place. As for precautions, always wear gloves when handling the brushes to avoid any potential injuries. Also, never try to install the brushes when the appliance is still plugged in. For maintenance, check the brushes regularly for wear and tear. If you notice that the brushes are getting too short or damaged, it's time to replace them. This will keep your appliance running smoothly and extend its lifespan.
