Carbon Motor Brushes suit Asko, Bosch Frontload Washer - Part # BT112

These motor carbon brushes are a perfect fit for certain Asko and Bosch front - loading washing machines. You'll get a pair of these top - notch brushes. The part numbers include BT112, BT - 112, and BT_112. They're quite similar to Qualtex part no. CAR91 and OEM Part No. 1603910, with the only difference being the opposite direction of the spade terminal points. The carbons measure 5mm x 12mm x 42mm, and you'll find 4617, L93MF7 written on them. The brushholder length is 47.5mm. The offset mounting hole spacing is 25mm, and the mounting holes are 15.6mm and 19.6mm from the front of the brushholder. The locating pins are 14.4mm apart, and the front locating pin is 10.4mm from the front of the brushholder. They come with a 4.8mm spade terminal. These brushes are used in some Asko and Bosch front - loading washing machines with an FHP motor. It's a common brush type for many washers with a new - style FHP motor. They fit Asko 10505 models with an FHP motor and brushes having L1 on the brushholder. When the brushes are worn out, you may notice erratic spinning or no spin at all. They're easy to install and come with a full guarantee. With over 25 years of experience supplying appliance parts to both trade and retail, you can buy with confidence.

Using these carbon motor brushes is easy. First, make sure your washing machine is turned off and unplugged. Then, locate the old brushes in your Asko or Bosch front - load washer and carefully remove them. Next, install the new brushes in their place. Ensure they are properly seated and the spade terminal is correctly connected. When it comes to maintenance, it's a good idea to check the brushes periodically, especially if you notice any issues with the spin cycle. If the brushes look worn out or damaged, replace them right away. As for storage, keep them in a dry and cool place to prevent any damage. And don't worry, if you have any problems, our full guarantee has you covered.