This is a high - quality neoprene rubber flat turntable drive belt, measuring 6mm in width and 0.6mm in thickness, specifically designed for belt - drive turntables. With cross - section dimensions of 5mm X 0.6mm, it offers excellent performance. We have a wide range of diameters available, from 120mm to 222mm. To make sure you get the right belt for your turntable, simply choose from the specified platter rim diameter ranges. If your platter's diameter falls outside these ranges, unfortunately, we can't provide a suitable belt from this listing. Remember, don't measure your old belt as it's likely stretched. Instead, measure the diameter of the rim under the platter where the belt runs around, that is, the distance from one side to the other across the center. We've been in the business of supplying appliance parts to both the trade and retail sectors for over 25 years. So, you can buy with complete confidence.
Using this turntable drive belt is easy. First, measure the diameter of the rim under the platter where the belt will run. Make sure to measure across the center from one side to the other. Don't rely on the measurement of your old, stretched belt. Once you've determined the correct size, choose the appropriate belt from the available platter rim diameter ranges. Then, carefully place the new belt around the rim under the platter. When it comes to maintenance, keep the belt clean. You can use a soft, dry cloth to wipe it gently. Avoid getting the belt wet or exposing it to harsh chemicals as this can damage the neoprene rubber. Also, store the belt in a cool, dry place when not in use. If you have any issues with the belt's fit or performance, refer back to the size selection guide. And remember, since we have 25 years of experience in supplying appliance parts, you can trust our products and feel free to reach out if you need any further assistance.
